Dom 332
Often imitated , never duplicated
- Joined
- Jan 28, 2021
- Messages
- 21,243
- Reaction score
- 46,616
- Points
- 153
the metal on the magnet could be from not cleaning the block 100% after the machining process. Like others have said , maybe put some fresh oil (buy something cheap and you can run it a qt low just idling) in it and run it again for a few minutes while keeping an eye on the oil pressure then cut open the filter and see what you got . If there is an issue another minute or 2 run time is not going to cause anymore damage than has already been done .
Make sure you clean your drain pan thoroughly before draining the new engine oil into it .
Last edited:












