I found a bunch of gold! I'm rich!

Well, now what

  • Change the oil, run it a few more miles, check again

    Votes: 32 78.0%
  • Pull it apart.

    Votes: 9 22.0%

  • Total voters
    41
Making noise at all? Squeeling? How much run time so far?

Heard the rockers ticking, they need adjustment. 10-15 miles, maybe 15 minutes idle time beyond that

Do the heads have solid bronze guides?

If we're taking pushrod guides, no they are not.

If it's something else, I'm retarded, talk slower
 
So my best friend has the twin motor to mine except not a stroker and different head. He built his in his basement. he put his together in 2010. Has less than 50 miles on the car since then.

Because of my issue I asked if we could pull his filter and take a look.

He drained the whole thing, and honestly looks very similar to mine.
 
Damn. That sucks. Sorry to se that.
 
They are AFR 185cc/58cc heads I bought in 2009. Not sure what they would have come with or if anyone changed them so I don't know the answer to that
what rockers are you using ?
 
Send the oil out for an analysis…
You could learn a lot..

flakes in a new build is common, but high traces of babbit material in the oil is bad news.

If you don’t hear any bad noises, I would put in fresh oil and filter, run it for 50-75 miles, drop the oil and send it in for analysis. You need to keep a sample of the oil you put in it to send along with the sample.

Did you use break in oil ?
Add any high zinc additives?
 
Scorpion 1.6 roller
ok just wanted to know if they were roller because non rollers can load the valve on an angel and cause valve guide wear and that could have been "the gold" you found . You have rollers so that is not an issue . That mostly is an issue when you get into higher than stock lifts and not having rollers
 
Have you pulled the distributor and looked at the gear yet?
 
Or broke, not sure.


I've been thinking about this dilema, and what could be causing that shit. If that is indeed bearing material, I'd be checking the thrust bearing. Like I mentioned earlier, you can check that with an indicator on the end of the balancer without taking anything apart. No idea if clutches cause these kind problems, wouldn't surprise me though

Buddy just trashed his thrust bearing with a new TH400, was able to drop the pan on roll in a new one without pulling the engine.
 
Send the oil out for an analysis…
You could learn a lot..

flakes in a new build is common, but high traces of babbit material in the oil is bad news.

If you don’t hear any bad noises, I would put in fresh oil and filter, run it for 50-75 miles, drop the oil and send it in for analysis. You need to keep a sample of the oil you put in it to send along with the sample.

Did you use break in oil ?
Add any high zinc additives?

Yes comp cams 10w30 break in oil

Who put the heads on this? Was copper coat used on the gaskets/mating surfaces?

Builder in Texas, no idea what he did, what he used. No info other than taking my money

Have you pulled the distributor and looked at the gear yet?

Negative, since it was so few miles and a composite gear I wasn't sure what kind of useful info I could attain by doing so. Do you recommend I check to see if it's getting chewed up? Or what should I look for
 
Back
Top