I found a bunch of gold! I'm rich!

Well, now what

  • Change the oil, run it a few more miles, check again

    Votes: 32 78.0%
  • Pull it apart.

    Votes: 9 22.0%

  • Total voters
    41
I thought about the thrust at first too, then remembered the stick thing. You can check the thrust fairly easily with an indicator on the balancer,
 
Hydraulic roller

We tightened 1/2 past zero lash. Some are a little loose, going to retighten and have a coolaid party
 
Not a "rebuild", it's all fresh.. I guess you probably meant the block in general....

Bought the block from competition products. All machining done, hot tank, magnafluxed, all the good stuff. Mix of ferrous and non ferrous
UGH! fill it with oil, go out and rip on that bad dog. Come back, sulk in the corner and make plans to start tearing it down I guess. Can you pull the pan in the car?
 
Meh, if you're anything like me (not an expert, I just have to do things over several times) pulling an engine after I've had it in and out a few times goes pretty quick. If all goes well, this is just a weekend project.
 
Put an end to the speculation, pull the injun get it on a injun stand, flip it over an pull the pan, pull the caps.

Pics of smoked bearings please.

If the bearings are fucked I'll hand deliver this engine to the builder that told me "the bearings were wrong and I had to put other ones on there"
 
Back
Top