It is composite gear 100%
I have no idea what is bronze in an engine. I'm not a builder and have minimal experience with anything engine related. I don't know shit about fuck when it comes to that.
I swirled the magnet around and I do have some ferrous metal as well.
That amount for iron is possibly normal.
I had an engine using NOS pistons and rings bored, and because they were not familiar with a chrome ring bore finish, they went overboard making it rough. IDK what they did but holy shit, the magnetic drain plug looked 50x worse than that, and yet the engine actually took me all over North America once broken in. Didn't burn a drop of oil. Slightly down on power, I felt, though.
Only advice I have is if it's the crank- it might not be, but if it is, spend the $ to have it repolished. People roll bearings in, and it becomes a matter of a few hundred hard hours and you are back at needing a repair.
I'd listen to SRGN, it is very likely cam bearings. H/Roller cams are either case hardened (yours, being a -8, I think), or steel. But between cam bearings not being given a precision check and the cams having runout, weird stuff happens.
I've seen it but do not know the correct way of going through it at a machine shop, to "blue print the tunnel" if necessary. I can speculate but speculation's not what you need. There are many here who *know*.