Ok, a lot has happened since I posted last. In my quest for trying to figure out what was going on with cylinder #4, I pulled the intake and passenger side head off. Friday morning, I took the parts to an engine builder’s house. He took every valve out one by one and inspected each and every valve and port. He did not find any cracks or anything abnormal. He told me to put it back together. He told me the head gasket looked brand new. No signs of heat anywhere.
I had an extra set of head gaskets at the house, so I got home and went to work. By 7pm I had fired the car off and everything sounded good. All of a sudden I have heat again in cylinder #4. Header primary was getting hot just like the rest. I cracked the throttle and it sounded clean and crisp, so I loaded up the car.
Saturday morning I hit Great Lakes Dragway. First pass car blew the tires off and then I got back in it and the car took off like it was on nitrous. It felt very strong. I got back to the pits and let the car cool off. As I’m headed up for my 2nd pass the car starts breaking up/missing/stumbling/etc., so I turned around and went back to the pits as I suspected #4 might be acting up again. I pulled and looked at every plug. They were all a light gray, not fuel soaked or black. I checked timing and it was good. I noticed that while in park just revving it with my hand that it was breaking up. If I revved it higher to get the secondaries to crack open it cleaned up. I suspected the intermediate circuit of the carb.
I went up and made another pass. I could feel it breaking up while doing my burnout until RPM went up high. On the transbrake it was fine. Taking off at WOT seemed fine. I was fighting traction all day, but still managed to new best 60’. 1.212
The issue remained all day. I tried lowering timing, changing from open adapter to 4 hole adapter, different rev limiter chips, launch rpms. The problem stayed all day. VERY FRUSTRATING.
The only real change from last week is those ceramic balls are no longer blocking the center air bleeds. I thought those air bleeds were only in play at idle?
In a little while I’m going to put the 4150 carb back on and see if it cleans up the missing at part throttle. If it does, I’ll know it’s the carb. If not, maybe I have an ignition issue.
I’m starting to research converting to a 2 circuit, but man I don’t want to start drilling or anything on a brand new carb just yet.
I was fighting the track and missing issue all day.