Todays epiphany…..last night while bumping timing I noticed that giving it about 2000-3000 rpm caused the timing to retard 2*.
I’m going to pull the distributor tomorrow and look at the wear. I already ordered a new gear just in case. Thinking about switching to a crank trigger this winter.
Liking the idea of the crank trigger.
Also, like others have mentioned, lot's of good discussion and knowledge to be learned here, and other threads like this one. Without throwing darts at the blue oval, which I am guilty of regularly, the hot rod in this case is clearly a stout running machine, and issues that I would normally not consider due to ignorance of the Ford design could be a cause. I would never think for a minute that my distributor gear was wearing in a chevy. Learning new stuff is ALWAYS a bonus!
As far as the 2 degree retard goes......if your timing is sitting where you made the last move and nothing picked up, but nothing slowed down, a 2 degree retard is not likely to be easily measured by time slips.
When trying to seek every ounce of potential from a drag car, it is really tough, and maybe even impossible without a ton of data acquisition.
I have tried both ways, and it sure makes things clear in a hurry when you spend yourself into a headache with grids, and a pile of racepak stuff.
Before having that stuff, I would simply play with jetting, timing, and an occasional plug check, and all of my decisions were made from my only source of data......a timeslip. Max ET was the goal, let the MPH land where it may, and as long as it repeated consistently, I would give the old girl new plugs every spring.....just because. When I got the coupe, we trial and errored that thing until the cows came home. It was fast, but inconsistent much of the time. I finally opened up the wallet and went to a grid, racepak, and top end shocks, with shock sensors. The journey got boring in a hurry after that. It took maybe two limited run trips to the track for me and Bangr to pin the setup down.
Granted, your ponycar is not in the same ET range as my junker, but considering it is a smallblock, small tire car, that thing is hauling ass. You have enough power to make it finicky.
I have no doubt you will get this thing lined out PR, due to your willingness to make it happen. Just keep this in mind......if you had a .75 to 1 second to the 1/8 slower car, most of the issues you are dealing with would not be there. From my personal experience, you have crossed the power/ET line that makes issues appear because the entire package is not 100% perfect. With 100 less horsepower, the inconsistent wheel speed at the line would vanish. At slower ET's, a dead hook is normal and perfectly fine.
This stuff can be mentally exhausting, but once in a while you have to back up and objectively assess just how far you have come recently. You are doing GREAT! Keep making educated decisions on changes, and don't let a lack of immediate returns get you down. You are really close to the max potential with the current package, it is jut a matter of making it work more regularly.