007dragracer2.0
Platinum Member
- Joined
- Aug 5, 2020
- Messages
- 12,999
- Reaction score
- 16,782
- Points
- 153
That second plug looks to be 10-12% too fat to me.
Honestly, they don't bother me one bit.Post 480 was done properly. I would guess those were lean. Barely any color. Keep in mind this is only 1/8th mile pass. The wideband showed 12.6-13.0.
Got it running.![]()
I put my pee pee in the fuel cell and it started.Did you forget to rub the fenders and tell it how much you love it?
It was only 47* outside. I just kept cranking it and giving it a squirt of fuel every few seconds and it started coughing and finally it lit off.Are you saying it helps to turn on the fuel pump?

Pushed up (pulled apart). Cam manufacturer said a melonized gear would be fine. I have an MSD pro -billet distributor. I called MSD and they said it was a melonized gear on it already. I relayed that to the cam manufacturer and he said, “you’re good to go then”.4.031" pulled down or pushed up?
The load of turning the oil pump should be keeping the gears in constant contact and the gear thrust down against the flange in the block.
Measure from the upper distributor flange in the block where the distributor housing seats to the lower flange in the block where the gear thrusts down against. That dimension should be between the minimum and maximum dimensions of the shaft end play, so the shaft is floating in the distributor when the gear is thrust down against the flange in the block.
Nobody needs to tell you that ain't supposed to look like that. The distributor gear material is not compatible with the cam gear.
Now, you need to look close at the gear on the cam and see how tore up it is.
Is the oil pump high pressure or high volume?
Another disturbing clue is evidence of contact on the back side of the distributor gear teeth. That happens when the pump is bound up trying to pump more oil than can flow through the bearing clearances and cannot rotate smoothly and the pulsation causes the hex shaft oil pump drive to twist like a torsion spring and oscillate, causing the gear teeth to chatter against each other and bump the back sides of the gears which ordinarily would never touch if the pump turned smoothly without chattering.
I knew something was up with timing, that’s what told me to pull it out. I think I found out where my 2mph went.It's obvious it's riding right on the tip of the tooth, that's going to affect your timing a lot more than if it was riding all the way down in the saddle.
I will cut the filter open. I think I answered all of the other questions except oil weight. I’m using Schaeffer’sIt's eating the gear. Need to cut open the oil filter and play in the pleats with a magnet. I like to use a big sheet of white butcher paper to open a filter on to make the debris and flack easier to see.
If the gear on the cam looks OK (good luck) I would try a composite gear.
How much oil pressure is there?
What kind of oil filter was used?
What weight oil?
