The last two ^ look a lot better than previous plug pictures.
Is the ceramic shiny at all at the tip where it transitions from the vertical side of the ceramic to the tip radius around the electrode?
Study the center electrode of a new (unused) plug. At the bottom of the V groove on the end of the groove under the side electrode I think you will see a tiny burr that was formed when the groove was cut or ground (however it is made), similar to what forms on the lower edge of a piece of steel when you grind it with a bench grinder, but just a tiny burr outside the end of the bottom of the groove.
If that burr was on the plug before it was run and is gone after the pass, the plug is too hot, there is too much advance or the A/F is lean, or some combination of the three causing too much heat.
I consider the little burr as the canary in the coal mine and expected to see it intact on all 8 plugs in a 13.8/1 SBC after Friday night follies in a 100 lap main on a 1/2 mile asphalt track. Iron BowTie head, #9 heat range.
When the heat range and tuneup are both right there will not be enough free oxygen from being too lean to erode it away and plug the tip will not get hot enough to melt the burr off the electrode.
Is the ceramic shiny at all at the tip where it transitions from the vertical side of the ceramic to the tip radius around the electrode?
Study the center electrode of a new (unused) plug. At the bottom of the V groove on the end of the groove under the side electrode I think you will see a tiny burr that was formed when the groove was cut or ground (however it is made), similar to what forms on the lower edge of a piece of steel when you grind it with a bench grinder, but just a tiny burr outside the end of the bottom of the groove.
If that burr was on the plug before it was run and is gone after the pass, the plug is too hot, there is too much advance or the A/F is lean, or some combination of the three causing too much heat.
I consider the little burr as the canary in the coal mine and expected to see it intact on all 8 plugs in a 13.8/1 SBC after Friday night follies in a 100 lap main on a 1/2 mile asphalt track. Iron BowTie head, #9 heat range.
When the heat range and tuneup are both right there will not be enough free oxygen from being too lean to erode it away and plug the tip will not get hot enough to melt the burr off the electrode.










