Foxy Green Foxbody Build

My A3's flowed 341cfm with me barely smoothing the machining marks in the bowl, but didn't have proper dimensions. Darin got them to 399.7 cfm along with the proper dimensions.
By stock I meant unported. These weren't offered on a passenger vehicle, they're the aluminum Cleveland head, basically a copy of the raised exhaust port PS head of the early 70's
I figured fox should be around my level with probably more tq to be honest.

That seems reasonable.

I was also a little surprised that Mike Jones said 550 HP with the cam that's close to the cam Fox has.

I'll guess the CI, CR, and cam aren't enough to support the "HP = CFM x 2" idea, but 550 sounds a bit low.

What really surprises me is the fact the more I learn, the less I know. :confused:
 
That seems reasonable.

I was also a little surprised that Mike Jones said 550 HP with the cam that's close to the cam Fox has.

I'll guess the CI, CR, and cam aren't enough to support the "HP = CFM x 2" idea, but 550 sounds a bit low.

What really surprises me is the fact the more I learn, the less I know. :confused:
Yeah, same here, I'd like to understand cams better, learned some, but I'll leave selection up to jones, lol. Really looking forward the one he made me for the xe. 🤞
The right combo sure seems to be the ticket!
I'm not trying to take attention from fox, I'm trying to show the effort I had into 600hp with big heads, compression and 409 cubes with 7000rpm.
AND A FUCKIN SINGLE PLANE 🤣😆

Oh, and a ROLLER (because thats an automatic 100hp also 🤦‍♂️)
 
That's my point.

If mph shows hp. And hp and weight determine your likely best ET possible.

Then my car has no where near the power I wanted, expected, or was sold on. Therefore will not have the ET either.
Sell the 185's and put some 220s on it.
 
A dual plane will cost you upper rpm power but makes a nicer torque curve. Won't get down the track as quick as a single plane with the proper gearing and/or torque convertor, but for a street car it is not a problem.

I used to have a customer that would go between a TPIS Mini Ram and an Accel Superram in his Vette. Super ram was better to the 330, but less mph and not as quick to the 1/4. The mini ram lost a lot of low end and midrange torque, but was the better intake at the track. Of course, this was with the correct convertor.
 
My A3's flowed 341cfm with me barely smoothing the machining marks in the bowl, but didn't have proper dimensions. Darin got them to 399.7 cfm along with the proper dimensions.
By stock I meant unported. These weren't offered on a passenger vehicle, they're the aluminum Cleveland head, basically a copy of the raised exhaust port PS head of the early 70's
I figured fox should be around my level with probably more tq to be honest.

I just don't know what to believe out there. There's more work to do to see what the car will do without drastic changes.

One guy says the average hp and broad curve is what's going to make my car ET where I want it.

Another guy will tell me I'm pissing torque out of the exhaust because of my duration split.

So back to the first paragraph, maybe my car would run a 6.60 at 101 if I learn to drive the fuckin thing.
 
I can almost guarantee 4.30 gears in my future based on the rpm I'm seeing
 
I have the promaxx 210s because they flowed nearly identical to afr's and didn't have raised exhaust ports
 
Back
Top