goneracin
Head of Crushin CheetoEaters and Krab Gappin
lolIf the throttle shaft is large enough and strong enough it doesn't flex, and the blade is not offset so much it gives it too strong a closing force, I guarantee it can be made to seal to minimum near zero air flow and be made to open gradually. Is the throttle shaft on ball bearings, like a Weber carb? If it isn't, it should be.
Have you studied the throttle linkage bell crank on the throttle body on a 2004-2006 GT-40? that has a throttle cable bell crank.
Nearly every Cobra kit car has throttle linkage from hell that makes them near impossible to drive in the rain because the carb comes off idle way to quick. The well worn video of the gal pulling out of a car show into the street in her boyfriend's Cobra and the car going crazy fishtailing and running into a pole and (was it ?) a Honda car a block down the street is an example.
I've made a asphalt circle track car more than a half-second faster on a 1/2 mile touching nothing but the throttle linkage, just fixing the bell crank arrangement so the driver had throttle control that wasn't just like an on/off switch.
you can watch it flex the butterfly, the shaft everything
every 500" car has made all kinds of linkage to give it some mechanical advantage
its why they idle, or they snap it open on the burnout or to go on the 2 step.
the shaft is 7" long, and centered in the bore
it sucks
but no one really cares because they have figured out how to work with it.
its a pisspoor setup, but its what they are stuck with











