Dom 332
Often imitated , never duplicated
- Joined
- Jan 28, 2021
- Messages
- 21,243
- Reaction score
- 46,616
- Points
- 153
I use a 1/8" or slightly bigger drill bit as a gauge between the converter tabs and flex plate to set converter depth. Then use quality washers to get the correct spacing .Stack a nickel and a dime, perfect converter clearance. Add shims to get the nickel and dime to fit snugly. I always weigh the shims to make sure they are the same, but it's probably not necessary.
Last edited:










