Tq converter mating issues…help!

Stack a nickel and a dime, perfect converter clearance. Add shims to get the nickel and dime to fit snugly. I always weigh the shims to make sure they are the same, but it's probably not necessary.
I use a 1/8" or slightly bigger drill bit as a gauge between the converter tabs and flex plate to set converter depth. Then use quality washers to get the correct spacing .
 
Last edited:
@Patriot Racer see post 21 , use what ever size drill bit you feel comfortable with for your spacing. Bottom converter out in the trans.Then add good quality washer or washers til your drill bit slides in and out (with slight resistance like setting valve lash) between the flex plate mounting point and washers. That is what I do and it has worked for 1000's of trouble free passes.
 
Last edited:
@Patriot Racer see post 21 , use what ever size drill bit you feel comfortable with for your spacing. Bottom converter out in the trans.Then add good quality washer or washers til your drill bit slides in and out (with slight resistance like setting valve lash) between the flex plate mounting point and washers. That is what I do and it has worked for 1000's of trouble free passes.
I read this at 4am half asleep and I was thinking, why the hell would I drill larger holes in the flexplate. 😆
 
Never knew there was an issue bolting a GM trans/converter to a Ford, I have a 400 behind my 306 with a swap meet converter that I had tightened up, never had an issue that I know of
 
Back
Top