Foxy Green Foxbody Build

Yep.

Don't fuck around with the car. Sort yourself out first Fox.

When you have got everything you can get out of it, not what you think you can get, then, it might be time to change some shit. Maybe.
This. Wring it out until your driving makes little difference in et from pass to pass. Then tune it.
 
Does a single plane eliminate any worries about primary to secondary full throttle carb balancing?

I don't like anything about intakes when it comes to carburetors and air/fuel distribution.

But I'm not the engineer of these things.

Annular boosters I think are the saving grace on street car stuff, but that's just AI telling me that
 
Maybe dial the power back some with timing and get a handle on the launch as you get the car to work dial a bit more in and get used to that and c so on. Sometimes less is more , I learned that racing in the FAST series. Creeping up on it I dropped nearly a second off my 1/4 mile et . Tires also can make a huge positive difference.
 
Guess im at the other end of the spectrum.. Said it before and ill say it again, put a better gear in it.

No sense in trying to learn that car until it's geared right..

Will be night and day different.
Might as well make use of the double overdrive 👍
But I believe what he's saying is that he had hoped for a higher mph to show he's getting the hp he was "promised", lol.
 
Am I crazy or is there somehow way too much timing in it? It only had 28 to 29 degrees in it.

20260823_211732.jpg20260823_211358.jpg
 
Fuck I need to be more clear.. those plugs have 200 miles of driving on them, no track time on those plugs. No vacuum advance
 
Last edited:
Just for thought....

This heap in the link below at 427ci, needs a 254 Intake / 266 Exhaust, .646 Intake / .646 Lift 113° LSA cam, and 11.1cr ... to make only 638hp with decent(but not the best) 259cc LS3 heads.

(not sure why they recommend 100 octane race gas. Probably for bad tuners. As just about any cammed n/a LS at only 11.1cr will run 93 unleaded no problems)


Not sure who's idea it was that a pump gas 427ci windsor with 210cc china heads and only a 250 cam would/could make 650hp

I think you would be lucky to be a genuine high 500's hp
 
Last edited:
I can almost guarantee 4.30 gears in my future based on the rpm I'm seeing
Yes more gear is needed but the trade off to not street drive the car with a 4.30 is there a 4.10 will get you in the middle of your power curve of the cam you have.
A question to ask yourself you want a race car or do you want a fun car to drive around town .
You have to give up something to do that and just be happy with how it runs at the track
 
My buddy has a 427 Windsor engine. He had to de-tune to make it more streetable.
 
He has the right mind set to spend more money and put a OD on the trans and run the 4.30 its only money
Brian said he has two overdrives on hos transmission now so I would certainly put 4.30's in there or so. What a difference that will make around town. I could not believe the feeling when I went from 4.30's to 4.88's.
 
When I was younger I had a 66 Dodge van Souped up 340, 280 something, degree cam, ported heads, 830 Holley carb, headers, four speed, slapper bars, 3.55 posi trac. When guys wanted to race me I would swap out the third member to a 4.88 and to drive to Florida from Mi. I would swap in a 2.73. PS it was a white Dodge van.
 
Back
Top