Foxy Green Foxbody Build

Bought a two step but I can't read. This won't work with my analog 6al.. guess I'll be sending it back

 
Last edited:
Or this one

Well here's another pile of shit to keep you busy


Or this one


Or this one

Yes. All of those. I'll go take a nap and read them(used) all (again) later. Big Baby.
 
All lines up with wallace dead on. I could be wrong on mph but I'm pretty sure he ran 9.36 at 143 1st run off the trailer. It's a ford c4 auto also
I believe you. My car has good mph for the ET, simply because I have bad ET for my mph! :)
I only bracket race, and for the most part I slow it down for 10.00 Index Racing, so ET does not matter to me. Makes being lazy easier! :)

I used to go 8.90 @ 156. That's a lot of MPH for the ET.
 
Forgot, I need to take the studs out so I can weld the pushrod guides.

Sunsabishes

Put it on the list
 
I believe you. My car has good mph for the ET, simply because I have bad ET for my mph! :)
I only bracket race, and for the most part I slow it down for 10.00 Index Racing, so ET does not matter to me. Makes being lazy easier! :)

I used to go 8.90 @ 156. That's a lot of MPH for the ET.
What's the engine combo on the 8.90 deal ? NA ?
I don't think I'll ever see 8's, lol
 
....little blue pills for the driver, little blue bottle for the car....it's gonna be a good night!!
I don't need no blue pills, been almost 3 months since wifes hysterectomy, sitting here like a grenade with the pin pulled trying to avoid even the slightest bump.
 
Installed brake lights under the rear of the car to light up the ground when braking. Installed one of those flasher modules on that circuit. Don't care what you think about it.20250824_151202.jpg
 
Carpet is back in, but didn't want to put the seats in until I tidy up a few things under the dash.

Wheels should be ready tomorrow. Hopefully get them on the car and have it on the ground Tuesday morning. Waiting on a new dimmer switch and dash vent from Ebay before I can put the whole dash back together
 
I think he did say it was revving higher than he wanted crossing the line
One day I decided to see how the engine felt at higher rpm than I wanted to cross the traps at, and I like speed....... So I didn't lift at the 1/4 and kept in it to 8800. The engine just kept pulling! And the track was getting too damn short! We had a semi-short shutdown at my home track back then, E-Town. It is one of the reasons Scott Kalitta died there as well as 1/4 mile Fuel Racing. I think I tried to figure out the mph but I forget what it came out to. Doesn't matter, on nitrous that poor little engine was at 8200 going 156.
 
The curse continues.

Went to pick up the wheels from powdercoat. I asked for satin black. They were semi gloss gunmetal.

He leaves for vacation for a week and a half taking his daughter to college. Guess it'll be a few more weeks. Gives me time to build a battery box and rear seat delete
 
Back
Top