Patriot Racer
Freeeeeeedom!
Went to the track last night and ran into a bunch of issues.
First off, I have gone down 12 jet sizes on this BLP carb and it’s still rich. 11.9-12.0 at WOT going down the track. Next after each pass (3 total), I couldn’t figure out why throttle would stick at 2500-3000 rpm after a run.
Scary shit coming down the return road watching temp creep up and scaring the shit out of the time slip guy. I finally figured it out. There is an Allen screw that goes in the carb from the bottom that the idle screw pushes against. While at WOT it kept vibrating upward and wouldn’t allow the secondaries to close. WTF BLP, a dab of loctite should have been put on that during assembly!
Next, while at WOT down track engine would start breaking up around 6700-6800 from what I could tell. It might even be breaking g up when I come off the transbrake. My rev limiter is set to 7500. I am using an old outdated Mallory 685 ignition and coil. Brand new MSD distributor, fire core wires and NGK 7 plugs.
The converter flashed last week to 5500 when I launched at 4200. Last night all launches were at 5000 and the converter didn’t do shit. It was supposed to have a 6300 stall. However, if I shift at 7000, it falls back to 6000, so that isn’t making sense.
I was in contact with SRGN last night. We tried to see how it would respond by closing spark plug gap from .032” to .025, but no change. I’m kind of lost as what to do next. BLP already told me to send the carb back.
I was contemplating upgrading the ignition this past winter and even made a thread about it. I held off. I’m going to get the power grid system at some point, but I don’t want to drop that cash right now and still end up with the same issue.
Looking for advice/suggestions on my next step.
First off, I have gone down 12 jet sizes on this BLP carb and it’s still rich. 11.9-12.0 at WOT going down the track. Next after each pass (3 total), I couldn’t figure out why throttle would stick at 2500-3000 rpm after a run.
Scary shit coming down the return road watching temp creep up and scaring the shit out of the time slip guy. I finally figured it out. There is an Allen screw that goes in the carb from the bottom that the idle screw pushes against. While at WOT it kept vibrating upward and wouldn’t allow the secondaries to close. WTF BLP, a dab of loctite should have been put on that during assembly!
Next, while at WOT down track engine would start breaking up around 6700-6800 from what I could tell. It might even be breaking g up when I come off the transbrake. My rev limiter is set to 7500. I am using an old outdated Mallory 685 ignition and coil. Brand new MSD distributor, fire core wires and NGK 7 plugs.
The converter flashed last week to 5500 when I launched at 4200. Last night all launches were at 5000 and the converter didn’t do shit. It was supposed to have a 6300 stall. However, if I shift at 7000, it falls back to 6000, so that isn’t making sense.
I was in contact with SRGN last night. We tried to see how it would respond by closing spark plug gap from .032” to .025, but no change. I’m kind of lost as what to do next. BLP already told me to send the carb back.
I was contemplating upgrading the ignition this past winter and even made a thread about it. I held off. I’m going to get the power grid system at some point, but I don’t want to drop that cash right now and still end up with the same issue.
Looking for advice/suggestions on my next step.










