Big Bore 427w

I know it doesn’t look much different, but I’ve been plugging away when I have time. It has oil in it now and it’s primed. Priming seemed to take forever to get oil to every rocker.

It is topped off with VP110, plugs are gapped and installed. Plug wires on and separators installed. Water is topped off in the radiator.

I will put the battery back in it tomorrow and run the water pump to check for leaks. Then if that goes well, I’ll run the fuel pump and set the bowl level and fuel pressure. It might be fired off this weekend.

 
Tried to fire off the car today, but it wasn’t to be. I am by myself, so I kept moving the distributor and attempting to start. I tried for like an hour, double checked firing order, TDC on #1, etc.

It barely coughed a couple time, but that was it. The ignition box is on and working. I gave up for tonight.
 
Tried to fire off the car today, but it wasn’t to be. I am by myself, so I kept moving the distributor and attempting to start. I tried for like an hour, double checked firing order, TDC on #1, etc.

It barely coughed a couple time, but that was it. The ignition box is on and working. I gave up for tonight.

Bummer man. There is always tomorrow to go through and check things over and try again.
 
Car has been fired off!!!!

Couldn’t sleep last night, went down to the garage around 3am and started messing with stuff. I knew it was getting fuel, but I wanted to verify spark.

I pulled number one plug wire and attached a spare spark plug to it, turned on my ignition, and rotated the distributor back and forth by hand while holding the spark plug to the header until I saw a spark.

Once I verified spark, I found the compression stroke for number one and then brought the balancer to about 22*. I then rotated the distributor again until I had spark. Right where it sparked I locked it down knowing timing would be close.

Waited patiently for the sun to come up and just tried it. I had to pump the throttle a couple times after it coughed to get it running.

It will not stay running, but it’s time to start adjusting this piece of shit carb until the BLP gets here.
 
Last edited:
I set the car on the ground to get a look at the wheel openings. I’m going to have to stretch the quarters. I will likely start on that in the coming days.


 
If that is a bias ply and you run the 1/4 it is going to hit.
 
Put a pro bracket radial on there and don't look back.
 
Do they grow at all? Looking at the clearance I have, if the suspension moves at all back there it’s going to rub and those are only 29’s.
No, I didn't notice any growth with the pro bracket radial.
 
Get you some 28's then you can race in small tire also.
I have 28’s, I stepped up to 29’s based on the gear set/transmission and numerous guys on the forum saying to go big on the tire lol

What nobody has any faith in my fabrication? :oops:
Car is ugly as fuck already, mind as well do this before it gets a wrap or paint some day.
 
Get to it, it’s not like you ever want to go to the track… ever…. There is an index race this weekend at Byron.
 
Ooh, my whole wheel opening is cut like you’re wanting to do.
 
I did not cut it the body was done when I got it.
Pretty big but looks factory to the untrained non fox body eye. I’ve had 32x14, 33x10.5w both on 15x15 wheels. Can probably fit 5to6” more width & 3to4” more height tires.
 
Back
Top