427 SBF

89 Fox 427 said:
For the record im using .020" before, and after peak lobe lift to come up with my measurements. This was advised to me in case of asymmetrical lobes this will be more accurate
Click to expand...

There should be a Fifth Law of Thermodynamics.

"They will manage to complicate everything"
 
Dot to dot. Right on at 111 degrees. I'll post a video somewhere so I can be double checked
 
89 Fox 427 said:
Dot to dot. Right on at 111 degrees. I'll post a video somewhere so I can be double checked
Click to expand...
And your cam card shows a 113° LSA but doesn't show the ICL ?

So the 2° advance is ground in.

And yer gear is giving you 4° advance/retard, not 2°, which I figured
 
I was thinking about this...

I've purchased one Crane, two Lunati, and three or four Comp and every one had the advance in the cam.
 
I guess the guys that spec the cam don't even know what comp is doing over there
 
89 Fox 427 said:
Link is good for a few days. Confirm I'm not crazy before I loctite this bitch together

It's a link, not a download.

limewire.com

Content not found | LimeWire

Content not found on LimeWire
limewire.com limewire.com
Click to expand...
Just asking because it's not shown, how did you find TDC?
Usually I keep turning the same direction but I know you went back then snuck up on it.
When yer splitting hairs on clearances having the heads installed with the springs you're using and valvetrain adjusted may change your readings a strawberry blonde pussy hair also
 
BOSS#1540 said:
Just asking because it's not shown, how did you find TDC?
Usually I keep turning the same direction but I know you went back then snuck up on it.
When yer splitting hairs on clearances having the heads installed with the springs you're using and valvetrain adjusted may change your readings a strawberry blonde pussy hair also
Click to expand...

.050" each direction with dial indicator, center of piston then zeroed the church gong wheel
 
Next up

Camshaft end play
Red loctite the cam bolt and retorque
Timing cover install.
Clean heads and install checker springs
 
89 Fox 427 said:
Next up

Camshaft end play
Red loctite the cam bolt and retorque
Timing cover install.
Clean heads and install checker springs
Click to expand...

Do you need to worry about cam play when you're using a retaining plate?
I have no idea...

Remember about that orange thread locker.
If something goes wrong it'll make disassembly a lot easier.
 
@89Fox427, call @Mitch and @Banger and get this muther fucker together already
 
You must log in or register to reply here.
Back
Top