FastFordsForever
Platinum Member
- Joined
- Jan 23, 2021
- Messages
- 35,686
- Reaction score
- 60,038
- Points
- 153
Pull the dist ,Put a drill on the oil pump drive and turn it a bunch after cleaning it first and it should show .
It's Schrodinger's Leak. Don't know if it's an obvious engine oil leak or not until you take it all apart or start the engine.
Pull the dist ,Put a drill on the oil pump drive and turn it a bunch after cleaning it first and it should show .
or..pulled my distrib to check the seal,motor ran a few minutes and now won't start?Next thread:
Why did my oil pump driveshaft fall into the pan & how do I get in out.![]()
Next thread:
Why did my oil pump driveshaft fall into the pan & how do I get in out.![]()
Next thread.
Got my drive shaft, took it on its first drive, smoked the clutch, what do I do now.?
Do they take generators on a drive to seat rings?Im not allowed to let it run at this time. Next run needs to be on the road so i don't fuck up ring seat
That Bob guy sure does love his music.Do they take generators on a drive to seat rings?
Goneracin seating the rings on my 638.......in less than 10 seconds.
Do they take generators on a drive to seat rings?
Goneracin seating the rings on my 638.......in less than 10 seconds.
Fox. Flat tap cam or roller?
Hyd roller
I didn't realize this was a diesel.Im not allowed to let it run at this time. Next run needs to be on the road so i don't fuck up ring seat
Comp 10w30 break in oilWhat oil
Comp 10w30 break in oil
Might need to go a thinner oil to keep pressure down but we'll see once on the road
What is pressure at idle