The morning crew check in

Good morning friends.

I have a 25' telescoping flag pole. I put a screw in each section because it wouldn't hold. It was a gift also but I think it came from Harbor Freight.

I have the same issue. Did you just use some self-tapping screws straight in the tubes?
 
Morning y’all !!!

Work continues on the crash repair of the Toyota..
Yesterday was a bitch.. found a sheet metal support for the front half of the fender and headlight assembly that had folded back on itself into an S shape. It’s part of the structural support an not a bolt on piece… it took two winches ( one on the dodge, one on the Yamaha chained to a tree) pulling at the same time at 45° heating with the blue tool to get it straight again.. the fuse and relay box is in that same area, so all that had to be protected from the heat with wet towels and a small piece of plywood… but got it done and finished up with the headlight install…

Today is fitting up the bumper cover… 267 plastic push pins and clips🙄🙄🙄
 
HD-wallpaper-good-morning-have-a-great-day-candy-donuts-greeting-coffee.jpg
 
Good Morning Gang

Hope the day is nice to you

Wife is on the operating table as I type getting a new right Knee.. total knee replacement at 48yo

Hope this goes well and she is chasing you around the house soon!
 
Back
Top