'69-'70 Boss 302 dual-point vacuum advance distributor with ball bearing breaker plate. The point sets are OE Ford but the righ set is standard production car points and the left set is the light weight contact and breaker arm high RPM type. The right set has been sitting long enough an oxide growth has formed on the Tungsten contacts.
People (idiots) would put Accel 40 oz. spring tension points in them, and then the high spring tension and "heavy duty" breaker arm (which because it was so heavy needed more spring tension) would pound the ball bearings loose and then the beaker plate flopped and wobbled so bad the dwell and timing could jump around 10 degrees or more. The heavy Accel points would ruin a good distributor in less than 500 miles.
After about 1972-73 the ball bearing breaker plate was NLA, so the fix was to convert to a standard single point breaker plate, use Mallory points (which would hold steady dwell to over 8000 RPM if the breaker cam was polished with 400 paper), and set up the advance curve to the specs* Ford published in the "off road only" literature.
As luck would have it, the correct spring part numbers for the Boss 302 curve were also used in the '65-'66 390 300HP distributors, so those springs were in the bone pile after you couldn't get them from Ford any longer.
With the correct "For Off Road Only" advance curve the Boss 302 ports were not too big or so big they kill the mid-range torque. What a load of crap. The idiots who ignored Ford engineer's advance curve advice and used super light springs so the curve is "all in by 2500" had to set the timing at 40 for peak HP at high RPM, and then the engine was so seriously over advanced in the mid-range it was down on power at the RPM where peak torque occurs.
The 40 degrees they need at 7000 to 8000 RPM is 6 degrees too much for best torque between 3000-4000. This has nothing to do with knock, with Chevron White Pump or Sonoco 260 they did not knock, it is simply too much timing for best power in the mid RPM range. This made the magazine idiots talk BS and they gave the Boss 302 engines a reputation for "the ports are so big they can't make torque" ... what a load of crap.
* Boss 302 advance curve: 16 initial, advance starts 1200 RPM, 30 at 2000 RPM, straight slope from 30 at 2000 to 40 at 8000 RPM.