O'Neal's new piston for the nitrous guys

[Mark O'Neal]

I do not recall... can the top part be round?

How are you going to get the pin out after you pound the shit out of the top of the piston?

 

[Steve439]

How are you going to get the pin out after you pound the shit out of the top of the piston?

Tannerite.

No matter the question, the answer is always "Tannerite".

 

[itey]

Yeah, well, he did create the Xtreme Energy cams to beat the shit out of our valvetrain ... so there's that.

https://www.facebook.com/camshaftschool/posts/pfbid0wnntf7G4tQrnFM7xmeWWRQUEzv97ZbBsnzfYfFVTp3BRax5d7vkwW6o427ZxWryvl

 

[Mike Beck]

We'd have had to add a couple of million in machines, and the contract was iffy at best. Believe it or not, the tolerances are far tighter on those things than they are on anything we run.

Probably should have done it. This industry is going away. I expected it, but not this quickly.

Yeah, but you may have dodged a bullet. I saw what can happen to a small company when it buys a bunch of machines for new contracts, then those contracts go up in flames.......... Poor guy bought four Mazacs (Spelling) and things were great for two years, then the bottom fell out. Told them come get the machines, there is no more money.

 

[Mark O'Neal]

Yeah, but you may have dodged a bullet. I saw what can happen to a small company when it buys a bunch of machines for new contracts, then those contracts go up in flames.......... Poor guy bought four Mazacs (Spelling) and things were great for two years, then the bottom fell out. Told them come get the machines, there is no more money.

If the world goes where I think it's going, there will be a shitload or stuff getting made ... with no one to buy it.