Connecting Rod, Small End

Maggifinn

Junior Member
Posts
203
Location
From the midnight sun where the hot springs flow
Joined
Aug 4, 2020
Reaction score
178
Points
43
These are my first GenIII Hemi rods, so the pin is a bit bigger than the SBC stuff I'm used to.
The rods are from Eagle, which are a first for me too. Bronze bushing.
Haven't measured anything yet, but I can push and twist the pin through the rod but it is pretty hard to do.
My assumption that the pin is tight, comes just from mock up assembly on the coffee table as I was unboxing the new internals.
 
Top